Grizzly front motor checklist for noises and/or error codesUpdated 2 months ago

1. Check for Error Codes

Look at the bottom of the display for any error codes.

Dissipate the controllers energy, you can view this tutorial on how to power-cycle.

2. Inspect and Reconnect the Front Motor Cable

Turn off the bike’s power.

• Disconnect the front motor cable at the connection point near the front wheel.  
• Take clear, close-up photos of both cable ends and send them to our customer support team at [email protected].
• Use a flash or direct light to ensure the pin sleeves and pins are visible.
• Reconnect the cable securely.
• Ensure the connection is fully seated and tight to prevent issues.

3. Check for Cable Damage

• Inspect the entire visible length of the front motor cable.
• Pay extra attention to where the cable enters the front motor.
• This area is covered by a spring that must be pulled back for a full inspection.
• For best results, remove the wheel before checking.

If you find any signs of damage, take a photo and send it for reference.