X-Class 60V: Relocating your Tail LightUpdated 20 days ago

Follow these steps to safely remove, reroute, and reinstall your tail light in its new position.

Tools needed

8 mm wrenchZip tiesZip tie cutters or scissors

1

Preparation and disassembly

• Remove the two bolts securing the plastic tray located under the seat.
• Roll the plastic tray out of the way to access the tail light mounting bracket.
• Remove the two nuts that hold the tail light to its bracket.
• Clip the zip ties from the forward portion of the plastic tray, then remove the tray completely from the bike.

2

Cable adjustment and relocation

• Locate the tail light extension cable and cut any zip ties holding it in place.
• Make sure all zip ties preventing the cable from stretching fully toward the rear are cut.
• Once there is sufficient slack, locate the tail light connector at the rear port of the frame, near where the cable enters.
• Disconnect the tail light and move it to the rear rack.

3

Installation on rear rack

• Route the cable using one of these two methods:
  • If the cable is long enough, run it back through the frame to the rear port.
  • Alternatively, run the cable to the center hole in the tail light mount and then back to the tail light.
• Secure the tail light by tightening the nuts with an 8 mm wrench.⚠

  Caution: Do not overtighten the nuts — only snug them up.

• Reconnect the tail light.

  Tip: Make sure the arrows on the connectors point directly at each other before clicking them together.

4

Final assembly

• Use zip ties to secure the cable in place and bundle any remaining cable back to the frame.
• Reinstall the plastic tray by following the removal steps in reverse order.

If you need any further assistance, please do not hesitate to reach out to us through our contact form here.